A build-up of grime on the float can make the float switch work improperly, according to the Handyman xChange website. Be sure to tighten the lower stop properly so that it will not come off. Unplug the old sump pump float switch and remove it.
Check if the capacitors are still good, but if it is making a lot of noise, the bearings are likely the problem.
I wrapped a little duct-tape around the float rod, just above the float. Spray the sump pump with a high powered hose to remove any excess grime stuck to the unit. To order a pump for your DIY grey water project, email Contact a local authorized service center in your area that will be able to service your equipment. Utilitech sump pump float adjustment Seeping water or water runoff is gathered in the sum pit.
